Drive test engineer
• To perform Drive Test for LTE/4G using GENEX Prob 3.14 & 3.15 (Pre-& Post Swap).
• Make report and Post Processing and analyzing call drops, call setup failure and coverage holes by GENEX Assistant.
• Attend Customer Complaints. Uplink and Downlink Throughput Testing, Ping testing, Data service Setup, Connectivity, Azimuth Height and Antenna tilt
• Monitoring RF parameters RSRP, RSRQ, RSSI, SINR, Serving & Neighboring.
• Site Audit (verification of azimuth Electrical & Mechanical tilts.
• Perform Drive Testing (Call Testing (CS) and Data Testing (PS)), Pre-Swap (Cluster) and Post Swap (Cluster) Drive Test using Nemo outdoor
• Site Verification TRX Test, Intra/Inter Site Hand Overs, identification of RxLev/RxQual Problems on Downlink, Co-channel interference in case of poor quality also identification of issues such as Interference, Overshoots, Call Drop, Block Call, HO Failure, Missing Neighbor etc.
• Identification & removal of swap (sector swap and partial swap).

Currently working as a project engineer at Techno source
Job responsibility are
• SITE Supervision
• Supervision of the project as per designed parameter.
• Design of Electrical Panels.
• Panel testing and Inspection
• Simulation testing
• Erection and Commissioning of the Industrial projects
• Site visits and project managements
• P.L.C, HMI and DRIVES Programming.
Projects
1) Maintenance call points (Indus motor company)
2) LED Factory Signs and Production Display Systems(Indus motor company)

Three month experience at NETKOM Pakistan working as an RF engineer. Responsible for all types of Drive tests eg.
• Drive test and optimization include checking the signal strength and quality of service
• Drive test of 3G and 4G LTE using
• Genex Probe and Tems software’s
• Performed stationary test stationary test at the cell site to check/ verify the throughput(DL/UL)

One month Internship experience at ATLAS HONDA PAKISTAN (Private) Ltd Industry
Working knowledge in the following shops:
• Maintenance department.
• Press Shop.
• Die Shop.
• Welding and Machine shop.
• Engine assembling shop.
• Power supply unit (PSU).
Projects
• Centralized alarm monitoring system at PSU unit.
• UPS room Temperature controller
• Centralized air controlling unit and placing solenoid valve at air supply line for controlling air leakage

One year experience at F.D & C (Private) Ltd Industry working on final year project in a capacity of Electrical and electronics engineering. Project responsibilities. Each discussed below:
• P.L.C Programming.
• Design of Electrical Panels.
• Instrument calibration, troubleshooting complex instruments issue.
• Design of HMI screens and Interface to system.
• Commissioning and Wiring of complete project