Crop Picture
NOTE: Do not upload any image that violates our Picture Policy. Doing so will result in the removal of the concerned image without prior notification.
概要
To utilize my knowledge and experience in Electrical Engineering and assist the organization to its highest level of performance.
工作经历
Automation Engineer
Design Analysis of PLC System
2: Ladder Programming of Complex system,
3: VFD Intercing with PLC
4: Analog control of VFD through PLC
5: Sinking of two VFD's
6: Working on S7-200. 300, 400 , 1200 Siemens PLC System
7: Working on Simatic Panel of SIEMENS (HMI)
8: Working on WINCC Flexible
9: Working on WINCC Explorer
10: PLC System Interfacing with digital and analog sensors
11: Stepper motor control using PLC
12: Servo Motor Control using PLC
13: Encoder interfacing with PLC
14: Prerartion of Electrical Drawings and Ladder drawings
15: Designin of HMI and SCADA System
Electrical Design Engineer
Preparation of Electrical Deliverables as detailed below for (Engineering) projects
• Single Line Diagrams.
• Switchgear Power drawings & Control Schematics
• Electrical power & lighting layouts
• Grounding & lightning protection layouts
• Electrical room equipment location layouts
• Panel board schedules.
• Electrical cable routing plans (cable tray/trench/duct bank/conduit layouts).
• Preparation of RFQs & BOQ for getting budgetary offers from Electrical Subcontractors & Suppliers dealing with Earthing, lightning protection, lighting, cables, raceway systems etc. based on project applicable codes and standards..
• Evaluating Protection & Metering requirements for MV & LV Switchgears, Industrial Motors, and Distribution Transformers.
• Sizing & Selection of LV & MV Switchgear and its components
• Reviewing the Technical Requisitions from the customer and preparing the clarification lists after scrutinizing the tender offer
• Checking availability/ adequacy of available technical documentation – SLD, Protection Requirements, Switchgear specifications etc
• Performing CT / VT sizing Calculations
• Preparing specifications sheets and performing design calculation for sizing
-Panel boards, Switchboards & Motor control centers.
• Transformers & Standby Generators.
• Capacitors (for power factor correction)
• Performing lighting calculations for indoor & outdoor industrial areas.
• Performing battery sizing calculations
• Design & Selection of LV / MV / HV Electrical Distribution Systems including but not limited to
• Switchgears (CTs,VTs, Protection Relays, Meters)
• LV Switchboards,Panel Boards , Load Centres
• Motor Control Centres
• Capacitor Banks , Harmonic Reactors
• Motor & Generator Protection
• Transformer Protection
