Crop Picture
NOTE: Do not upload any image that violates our Picture Policy. Doing so will result in the removal of the concerned image without prior notification.
概要
I am committed to work within an organization where I can utilize and enhance my skills to meet organization’s goals and
objectives.I am passionate about working in a team where I can contribute my technical skills in a practical environment
and achieve my career goals.
项目
工作经历
Assistant Manager paint Shop
Maintain shop and give report to technical manager.
1-Check pre-treatment line maintain stock on daily base.
2-Control Ed line, UF system and check daily reports of different temperature, chemical component, permeate and
3-flux rate according to standard value provided by Nippon paints.
4-Maintenance different sections of shop weekly and report that generated submitted to senior technical manager.
5-Consult all theoretical and technical knowledge with Nippon engineer in case of ED paint DFT and phosphate
coating problems.
Plant Engineer(supervision fabrication and installations)
Plant contain four main bodies (shops) that are followings.
1-Welding shop
2-ED (Electric Deposit shop that have thirteen tanks four consist of HSS and nine MS that contain ED paints, rinsing
water and phosphate with heat exchangers).
3-Paint shop (having main three ovens and two main spray booths)
4-Assembly Shop &Test line(two types of assembly line for upper and bottom assembly line and finally test line that
have seven main test benches Headlight tester, Sideslip tester, Corner tester, Speed tester, Brake tester, Axle
5-load tester and Horn Noise frequency tester and last one is Rain shower.
United auto Industries pvt.Limited
Internship
• Cylinder head (work with A.M on this section)
• Crankshaft (work on kiraPridor Machine and FQM)
• Gear and Heat treatment (Test different heat process to check quality of different gears and shaft).
Internship
Work at pulping plant, bleaching plant with senior engineer in instrumentation and hydraulic lab.
To learn about different kind of sensors, actuators used in different section PM1 PM2 PM3.
Report submitted to technical manager at the end of this tenure.
Internship
Work at Pulp plant, packaging plant and shear knowledge with senior Engineers.
